Before installing an Domino server, make sure you have done the following:

• Installed one or more NICs on the system.
• Installed protocol software if necessary.
• Installed all network drivers in the correct directories.
• Installed any network software required for the protocols. For more information, see the vendor's documentation.

After you run the setup program, you may need to complete one or more of these tasks to finish setting up Domino on the network:

• Change the default names assigned to Notes® named networks make them consistent with actual network topography.
• Fine-tune network port setup by adding, enabling, renaming, reordering, disabling, or deleting ports or by enabling network encryption or compression on a port.
• Complete tasks to set up TCP/IP or NETBIOS protocol.

Related tasks
Setting up Notes named networks
Disabling a network port on a server
Enabling a network port on a server
Server setup tasks specific to TCP/IP

Feedback on Help or Product Usability?

Help on Help

All Help Contents

Feedback on Help or Usability?

Help on Help